Trim Pieces,

Finishing Touches to Complete Your Project.

Trim Pieces,

Finishing Touches to Complete Your Project.

Trim Pieces,

Finishing Touches to Complete Your Project.

Essentials! Don’t Leave Your Floors Looking Incomplete

T-molding

Transition piece to connect floors that rise at the same surface level. Ex: laminate to laminate, laminate to tile, laminate to hardwood.

T-molding

Transition piece to connect floors that rise at the same surface level. Ex: laminate to laminate, laminate to tile, laminate to hardwood.

Reducer

Transition between two floors that do not meet at the same surface level, where one floor is about 1/8″ higher/lower than the other connecting to it. Ex: luxury vinyl to hardwood, luxury vinyl to laminate, luxury vinyl to tile.

End-Cap

Transition that caps off the ends of your new floor where they meet up against an entry/exit door, fireplace or other endpoints. Also to be used on floors meeting up with carpet.

End-Cap

Transition that caps off the ends of your new floor where they meet up against an entry/exit door, fireplace or other endpoints. Also to be used on floors meeting up with carpet.

Quarter-round

Molding primarily used to cover 1/4″ gaps between floors and cabinets. Other uses may include against sliding door, or wall baseboard if baseboards are not removed and re-installed during new floor installation.

Stair-nose

Stair molding to go on the top front edge of each stair tread or step. Primarily comes in two styles for a finishing touch

Overlap

Classic and traditional stair molding that overlaps the flooring on the stair tread creating a “bump” at the end of each step.

Flush

Modern stair molding that is installed as a continuation of the flooring on the stair tread, creating a flush transition between the floor and stair-nose, eliminating the “bump” you would normally get with an overlap stair-nose.